Doxmall RGB LED Rock Lights Kit 8 Pods Underglow Multicolor Neon Light Pods with Bluetooth App Control Timing Function Music Mode IP68 Exterior Wheel Well Light for Truck ATV UTV RZR SUV

App Buttons:

1. Click Top Left Menu Tab Icon
2. Select the Light List button
3. Click on the Ble. Light (OPT7 Rock Lights)
4. Click “Connect” at the top right of the screen
5. Begin to use the color wheel to change the LED colors

Other Menu Settings;

Scene Modes:
Click on the preset scene mode settings to enjoy a colorful light show synced with your rock lights.
Music Mode:
Click the top right file button to connect to your phone’s music files and have your light Sound LEDs match to the beats.
Clock Mode:
Set up a timer for your Rock Lights turn on or off at specific times.
User Guide:
Find all information on every setting in the app.

Led Rock Light , Free downloade App .

Download the free  app by taking a photo of the QR Code below . Or check “OLblelight ” on App Store .

Package Included:

Install  ( 2 ways )

Remember, the rock light pods become extremely hot when in use, so you will not want to install the pods or control box underneath or on any sensitive material or power lines under your vehicle for safety.

Tools :

2.5mm Allen wrench
7 mm wrenchor socket
5/32 inch drill bit

Install Stepts :

1. Choose the mounting locations for each of the LED pods and the control box. Please refer to your vehicles owner’s manual for safe areas to install additional lighting and wiring.

2. Determine where the wires will run through. If needed, drill a hole(s) for the wire connector to pass through.

3. Mark and begin driling each mounting hole  with a 5/32″ drill bit.

4. Install the LED Pods by themselves for a flat install or with the Rubber Mounting Pads for rounded surfaces.

5. Insert the two 25mm Screws through the LED Pod screw holes and Rubber Mounting Pad.

6. Secure the Screw and Pods with the Washers and Nuts to install flush with the drilled holes.

7. Secure the Pods by tightening the Screws for a snug fit away from any wiring or moving parts.
Caution: The Pods become very hot during use, which can cause severe damage to any lelectrical, rubber, or moving parts that are exposed and too close to your Pods. Keep Pods away from any parts that can be damaged by extreme heat exposure.

8. Connect all of the Pod Cables to the Splitter Cable and secure by screwing locking the collars from the Spltter Cable. Secure the Caps by tightening the end connections with your fingers.

9. Connect both sets of Splitter Cable input wires to the vehicle electrical system using additional power wire and fuse with fuse holder. Red is positive (+). Black is negative (-).

10. Once the Pods and Control Box electrical wiring are all safely connected to your vehicle’s electrical system, you can now begin using the Rock Light Pods with the Bluetooth App on your Smartphone. Feel free to share a review of your installation with info about your exact off-road vehicle so other customers understand too! Rock on!